To use this menu, you must have the latest version of the gamepad's firmware installed.
You can set power-save sleeping time, LED brightness, calibration stick & trigger keys, and naming of gamepad
β’
Sleeping time: 30 min is the default value, can adjust it to 5,10, 60 min.
β’
LED Brightness: Adjust 15 steps, but no allow to switch off completely
β’
Calibration of a stick, trigger
Calibration for Sticks (L-Stick, R-Stick)
When you using a gamepad sometimes or heavily, the position of the analog stick or trigger could be non-centered. In such a case, this calibration app can adjust the position accordingly again to be centered.
1.
Select stick icon (LS/RS)
2.
Draw stick and release it, move it to the center point
3.
Calculating center value, waiting until complete.
4.
Move the stick to each direction and wait until completed. Upβ downβ leftβ right direction by turn.
5.
All steps end, check its position point
If you press CANCEL, the calibration process will be canceled.
Calibration of trigger (LT/RT, a.k.a. L2/R2)
If the trigger value is not O when it is idle status without moving, or if it is not reaching the max value when the triggered is fully pulled.
1.
Start trigger calibration (LT/RT)
2.
Pull it maximum and release slowly
3.
Calculating center value, waiting until complete.
4.
According to pop-up, push trigger, and wait the progress bar moves.
5.
After calibration complete, check its function and save to exit
If you press CANCEL, the calibration process will be canceled.